· Step 4: While your Device is in Download mode, connect it to your PC using USB cables. Step 5: Run Odin as an administrator on your PC and click on the AP button. Go to the location of the extracted firmware file and select it. Step 6: Press on the “Start” button to begin the flashing bltadwin.ruted Reading Time: 5 mins. · Have your computer powered on, and have the USB cable plugged into the computer but not the phone. Turn the phone off, take out the battery, wait a few seconds, then hold down the volume buttons, and plug the cable into the phone. You should be in download mode, and the computer SHOULD start installing the drivers automatically. · As earlier stated the problem comes when the Android device is not able to exit the download mode due to some factors such as scrambles or corrupted Android operating system. One of the many causes of this problem is when the user has installed certain applications that prevent the device from booting as it should.
Sounds very familiar! Same problem here, had a failed rom install, reboot, then lost connection with Odin. Will not see device in download mode. Looks like the device disables the usb port in download mode. Lots of folks with samsung tab units with the same problem. Sure would like to find a cure. Any help would be appreciated. Android device not connecting to PC over USB in MTP mode Connecting an Android mobile computer to a PC in MTP (file transfer) mode Android 6 device not connecting to PC over USB Unable to tether Android device for file transfer. When connecting Android device to PC, driver installation fails, or is not being picked up at all. I tried to flash the latest BL to my phone and got stuck at the splash screen. (Samsung Galaxy S7 Edge, powered by android). Now, I can't go to download mode or the recovery Post added at PM Previous post was at PM I fixed it, what I did was Hold Vol - Home and Power key constantly.
Go to “Settings” on your Android device - “Storage” - click the icon “More” - select “USB computer connection” - choose “Media device(MTP)” - connect your Android to computer again. If your device is not in Download mode, you can do this by powering off your device, hold the volume down, power and home keys and then release. Press the volume up key when shown a boot menu. A similar method is used for devices without a home button, with using the Bixby button instead of the home button and pressing the power button, not holding it. Your computer detects an Android device as an MTP device. However, there is a possibility that there is a problem with MTP drivers of your computer if Android won't connect to PC. To check that.
0コメント